Updated on March 8, 2022

UC500 Overview

Estimated reading: 2 minutes 481 views

UC500 Overview

Front Panel

word image 18

Port Description
WAN/LAN OpenVox UC500 provides two 10/100Mbps adaptive RJ45 Ethernet ports, and supports 3 Ethernet modes. The default mode is “Single”.

  • Single: LAN port will be used for uplink connection. WAN port is disabled.
  • Bridge: LAN port will be used for uplink connection. WAN port will be used as bridge for PC connection.
  • Dual: Both LAN and WAN ports can be used for uplink connection.
SD Slot Insert SD card to store auto recording files.
USB Port Insert USB storage to store auto recording files or recovery system.
Reset Button Press and hold for 10 seconds to restore the factory defaults.
Power Inlet Connect the supplied power supply to the port.
LED Indication Status Description
PWR Power status On Power connected.
Off Power disconnected.
RUN System status Blinking slowly (Green 1s and Flash 1s) The system is starting up.
Keep blinking (Green 2s and Flash 0.1s) The system is running properly.
Blinking rapidly (Green 0.3s and Flash 0.3s) The system is Factory Resetting.
Off The system goes wrong.
Charging Charging status of UPS On The UPS is charging.
Off The UPS is fully charged。
WAN WAN status Static Linked normally.
Blinking In communication.
Off Off-line.
LAN LAN status Static Linked normally.
Blinking In communication.
Off Off-line.

Rear Panel

word image 19 word image 20

Port Description
RJ11
  • FXO port (red light): For the connection of PSTN lines or FXS ports of traditional PBX.
  • FXS port (green light): For the connection of analog phones.

Note: The sequence number of the ports corresponds to that of the Indicator lights in the front panel. (I.e. the LED lights in the front indicate the connection status of the corresponding ports at the back panel.)
Protective Earth Connect to the ground to reduce the risk of electrocution to the user or protect the PBX from the bad effects of external noise in the case of a lightning strike.
LED Indication Status Description
FXO FXO Line status Red: static The PSTN line is idle.
Red: blinking slowly No PSTN line is connected to the FXO port.
Red: blinking rapidly The PSTN line is busy.
Red: Off The PSTN line is unavailable.
FXS FXS Line status Green: static The analog phone is idle.
Green: blinking The analog phone is busy.
Green: Off The analog phone is unavailable.

 

Leave a Comment

CONTENTS