Connect UC-Series VoIP PBX to OpenVPN Server

You can connect UC-Series VoIP PBX to the OpenVPN server by manual configuration or OpenVPN files package.

• Manual Configuration: If your VPN provider provides you the with information of OpenVPN server settings, certification files and key files, you can manually configure the OpenVPN client on UC-Series VoIP PBX and connect to OpenVPN Server.
• Upload OpenVPN Package: If your VPN provider provides you with a connection file, certification files and key files, you can compress these files, upload the package to UC-Series VoIP PBX and connect to OpenVPN Server.Note:

Manual Configuration on UC-Series VoIP PBX

1. Go to System > Network > VPN Client > OpenVPN.

1. select the checkbox of Enable OpenVPN.
2. In the drop-down list of Type, select Manual Configuration.
3. Set the OpenVPN client settings according to the OpenVPN server.
   • Server IP Address: Enter the IP address of the OpenVPN server.
   • Server Port: Enter the port of the OpenVPN server.
   • Username: Optional. Enter the username to access the VPN server.
   • Password: Optional. Enter the username to access the VPN server.
   • Protocol: Select the same protocol as the OpenVPN server.
   • Device Mode: Select the same mode as the OpenVPN server.
   • Proxy Server: If the PBX is connected through an HTTP proxy to reach the OpenVPN server, enter the proxy server.
   • Proxy Port: If the PBX is connected through an HTTP proxy to reach the OpenVPN server, enter the proxy port.
   • Compression: Enable or disable compression for data stream. The server and client should be the same setting.
   • Encryption: Select the same type as the OpenVPN server.
4. Upload certificates and keys.

• • CA Cert: Upload a CA certificate.
  • Cert: Upload a Client certificate.
  • Key: Upload a Client key.
  • TLS Authentication: Enable or disable TLS authentication.
  • TA Key: If you enable TLS Authentication, upload a TA key.

1. Click Save and check the VPN connect status at the end of VPN page.

Upload OpenVPN Package

1. Go to Go to System > Network > VPN Client > OpenVPN, select the checkbox of Enable OpenVPN.
2. In the drop-down list of Type, select Upload OpenVPN Package.
3. Click Browse, select the OpenVPN package.
4. Click Save and check the VPN connect status at the end of VPN page.