Navigation: Configuration > Configuration Guide (Web Mode) >
This topic describes common configuration policies and services including number change, intelligent routing, and call restriction.
ϒ⁄Setting Number Conversion Mode
ϒ⁄This topic describes how to understand and set the calling and called number change, short and long numbers, and number mapping.
ϒ⁄Configuring a Common Administrator
ϒ⁄Multiple administrators can be configured on the web management platform to perform hierarchical service management. The multiple administrators is supported in X1900 V2.0 or a later version.
ϒ⁄Configure the Collect Call Service
ϒ⁄After user A enables the collect call service for specific call types, user A pays for such incoming calls. The collect call service is supported in X1900 V2.0 or a later version.
ϒ⁄Configuring the Function of Automatically Adding the Outgoing Prefix to a Displayed Calling Number
ϒ⁄For incoming calls, you can configure the function of automatically adding the outgoing prefix to a displayed calling number for easy callback.
ϒ⁄Configuring Call Restriction Policies
ϒ⁄This topic describes how to configure various call restriction polices so that the call meeting specific conditions are restricted.
ϒ⁄Configuring Intelligent Routing
ϒ⁄Intelligent routing means that the unified gateway can select a trunk and office route based on a certain routing policy, for example, by time or by lowest tariff.
ϒ⁄Configuring the IP-Phone Console Service
ϒ⁄This topic describes how to configure and use the IP-phone console service of the unified gateway. If you are using console software as the console system, skip this topic.
ϒ⁄Configuring Two-Stage Dial Tone
ϒ⁄When a user dials an outgoing prefix, the user hears the two-stage dial tone (beep tone) and then dials the subsequent number.
ϒ⁄Configuring Signaling Encryption
ϒ⁄The unified gateway can encrypt SIP signaling using TLS to improve the security and reliability of voice communication.
ϒ⁄Configuring Media Stream Encryption
ϒ⁄The unified gateway supports SRTP-based media stream encryption for voice calls to ensure the security of user communication information and prevent malicious eavesdropping.
ϒ⁄Customizing AT0 Interface Parameters
ϒ⁄The signal tone and impedance settings preset for the unified gateway may fail to meet site requirements and cause exceptions to calls routed through AT0 trunks. When this occurs, you need to customize AT0 interface parameters based on the local standards. Only X1911, X1960, and X1981 support this function.
ϒ⁄This topic describes the IPT services provided by the UScale solution. For details about the feature description, configuration, and usage, see the Feature Guide.
ϒ⁄This topic describes how to configure the SNMP function, including enabling the SNMP function, adding SNMP manager IP addresses, adding SNMP user groups, and adding SNMP users.
Parent Topic: Configuration Guide (Web Mode)