Navigation: Configuration > Configuration Guide (Web Mode) > Advanced Configuration >
Intelligent routing means that the unified gateway can select a trunk and office route based on a certain routing policy, for example, by time or by lowest tariff.
ϒ⁄If routing fails based on the policy for the active route selection code, the system reselects a route based on the policy for the standby route selection code corresponding to the routing or call failure processing index. The system can also reanalyze the called number and then reselect a route.
ϒ⁄Configuring Time-Based Routing
ϒ⁄Poll the office routes according to the office route IDs in ascending sequence till an office route that contains the system time and idle circuits is found.
ϒ⁄Configuring Routing Based on Charging Rate
ϒ⁄Poll the office routes according to the charging rate in ascending sequence to query the idle circuits. Poll the office routes according to the office route IDs in ascending sequence if office routes have the same charging rate. If no idle circuit is found, poll the office routes according to the office routes that are not configured with the charging rate in ascending sequence till the idle circuits are found.
ϒ⁄Configuring Routing Based on Load Balancing
ϒ⁄Poll the office routes according to the office route IDs in ascending sequence till an office route that contains idle circuits is found. The later calls will be polled from the office route after the office route that is selected by the preceding call.
ϒ⁄Configuring Routing Based on Load Percentage
ϒ⁄Except the office routes whose load percentages are set to 100%, poll the office routes according to the load percentages in descending sequence.
ϒ⁄Configuring Routing Based on the User Right Level
ϒ⁄Poll the office routes according to the user priority levels which the office routes belong to from high to low. Poll the office routes according to the office route IDs in ascending sequence if office routes belong to the same user right level. Till the user right level which the office route belongs to is equal to or lower than the user right level and the office route contains idle circuits is found.
ϒ⁄Configuring Routing Based on Trunk Link Balance
ϒ⁄Poll the office routes according to the office route IDs in ascending sequence till an office route that contains idle circuits is found.
ϒ⁄Configuring Rerouting Analysis
ϒ⁄Configure rerouting analysis so that all outgoing calls from users in a specified call source are routed through the specified office route.
ϒ⁄Configure trunk bearer to determine whether calling and called number change are implemented when users make outgoing calls through the PSTN and whether they hear the ringback tone of the peer office.
ϒ⁄This topic describes how to configure outgoing call rights and implement calling and called number changes for incoming calls routed through a specified trunk.
Parent Topic: Advanced Configuration