Navigation: Configuration > Configuration Guide (Web Mode) > Configuring Trunks >
This topic describes how to configure various signaling data to connect the unified gateway to the peer device through trunks.
ϒ⁄This topic describes how to configure a SIP trunk connection between the unified gateway and the peer device. The peer device must support the SIP trunk.
ϒ⁄This topic describes how to configure a PRA trunk connection between the unified gateway and the peer device.
ϒ⁄Configuring an SS7 Trunk (Voice Data and Signaling Data Sent Through the Same Channel)
ϒ⁄There are two scenarios when the unified gateway is connected to the peer device through the SS7 trunk. This topic describes how to configure an SS7 trunk in the scenario where voice data and signaling data are sent through the same channel to the peer device.
ϒ⁄This topic describes how to configure a QSIG trunk connection between the unified gateway and the peer device.
ϒ⁄This topic describes how to configure an R2 trunk connection between the unified gateway and the peer device.
ϒ⁄This topic describes how to configure an AT0 trunk connection between the unified gateway and the peer device. U1980 does not support the AT0 trunk.
Parent Topic: Configuring Trunks