Navigation: Configuration > Configuration Examples in Typical Scenarios > Traditional PBX Interworking Scenario >
This topic describes how to configure SIP user numbers based on the data plan.
Procedure
1.Log in to the unified gateway web management system.
2.Add 10 DID users whose numbers start from 7000 (long number: 68907000) in a batch.
a.Choose User > SIP User.
b.Click Create, and set the relevant parameters, as shown in Figure 1.
From V200R003C30SPC300, two additional parameters, namely Service password and Self-service login password, are provided for a user being created. You can log in to the web management system and configure Service password and Self-service login password, or run the config system subscriber defaultpwd password password webpassword webpassword command in global config mode to configure the default service password and self-service login password for the user. If the passwords are not configured using either the command or web management system, the user fails to be created. If the passwords are configured using both the command and web management system, the configurations in the web management system prevail.
The Service password and Self-service login password are added in the unified gateway V200R003C30SPC300.
c.Click OK.
3.Add 10 non-DID users whose numbers start from 7010 in a batch.
a.Choose User > SIP User.
b.Click Create, and set the relevant parameters.
The Service password and Self-service login password are added in the unified gateway V200R003C30SPC300.
c.Click OK.
4.Click Data Save in the upper right corner of the web management system.
The unsaved configurations will be deleted after the device is restarted.
Parent Topic: Traditional PBX Interworking Scenario