Navigation: Configuration > Feature Guide > Voice Service > Calling Name Identification Restriction >
Configuring CNIR Rights
1.Log in to the X1900 series unified gateway using the CLI and access the Config mode.
2.Add the CNIR permission for a user.
config modify subscriber
Table 1 Parameters for adding the CNIR permission
Parameter |
Description |
dn |
Enter the user number for which the service is to be enabled. |
operatenewservice |
ϒ⁄To enable the service, set this parameter to add. ϒ⁄To disable the service, set this parameter to del. |
newservicerights |
Set this parameter to CNIR. |
3.Run the save command to save the configuration.
Configuring the Calling Number Display Prefix
1.Use an administrator account to log in to the web management system of the X1900 series unified gateway.
2.Choose Trunk > Called Prefix Configuration and click Create. On the Create Prefix page that is displayed, configure prefix ##.
ϒ⁄Prefix: ##
ϒ⁄Service type: Supplementary service
ϒ⁄Call property: Display calling number
ϒ⁄Use default values of other parameters.
3.In the upper right corner of the web page, click 
to save the configuration.
Enabling Software Parameter 496
config softargu type 496 value 1 (default value: 0)
ϒ⁄When software parameter 496 is set to 1, the CLIR feature takes effect for outgoing calls, but not intra-office calls.
ϒ⁄When software parameter 496 is set to 0, the CLIR feature takes effect for intra-office calls, but not outgoing calls.
Parent Topic: Calling Name Identification Restriction