This document describes the detailed steps for connecting the service board to Freepbx.
Follow the steps below to configure a two-way call between the phone and the gateway.
•Outgoing calls: from Freepbx's SIP extension 3002 to the gateway via trunk 1008.
•Incoming call: Call from outside line to gateway, through SIP trunk 1008 to Freepbx, then the call is sent to 3002 SIP extension through Freepbx.
In the following steps, the following parameters are mandatory to be configured, other parameters can be configured according to your needs.
Step 1: Create a SIP trunk in the Freepbx server
Please login to your Freepbx server and create a SIP trunk (1008). In the Freepbx server webpage, please select "Connectivity->Trunks->Add SIP (chan_sip) Trunk" to set it like this.
Step 2: Create a sip extension named 3002
Create a sip extension named 3002 in the web page "Apply ---->Extensions".
Step 3: Configure Routing in Freepbx
Outbound routing rules.
Inbound routing rules.
Step 4: Set the network parameters in the network
Log in to the network in your browser and set the network parameters. The following figure is an example for reference only.
Step 5: Create a SIP endpoint in the network
Please set up the SIP trunk. The following figure shows detailed information about how to set up.
For other parameters in SIP, please set them according to your needs, they are not required in simple calls.
Step 6: Set up routing rules in the web page
Set the outbound and inbound routing rules as shown below.
Inbound routing rules.
Outbound routing rules.
Step 7: Register a SIP extension through the software
Take advantage of SIP software such as Xlite, eyeBeam to register a SIP extension (3002).
Use SIP software such as Xlite, eyeBeam to register a SIP extension (3002).
Test:
Incoming call test: Call the number of Port1 on the gateway through your phone and see if 3002 will ring. If 3002 rings, it means your configuration is successful; otherwise, it means there is something wrong with your configuration, please check the configuration.
Outgoing call test: Call your cell phone number on the 3002 extension registered in the software phone. If your phone rings, it means your configuration is OK; otherwise, please check your configuration.
Parent topic: AIU-8