Navigation: Configuration > Configuration Examples in Typical Scenarios > Multi-Node Network Scenario (Peer-to-Peer) >
At each node, configure office routes, prefixes, and SIP trunks to the other nodes based on the data plan to implement interconnection between these nodes.
This topic uses node 1 as an example. Configure nodes 2 and 3 based on the data plan and by referring to configuration procedure for node 1.
Prerequisites
ϒ⁄You have completed the data plan for node interconnection. For the detailed data plan, see Scenario.
ϒ⁄You have verified the following functions in a single-node network:
§Intra-office basic voice calling.
§Connection to the carrier network.
Configuring Office Route Selection Codes
In the current scenario, you need to configure the following office route selection codes at node 1:
ϒ⁄Office route selection code 12 to node 2
ϒ⁄Office route selection code 13 to node 3
1.Choose Trunk > Office Route Configuration > Office Route Selection Code.
2.Click Create.
3.Configure an office route selection code (for example, 12) and click OK.
4.Repeat steps 2 and 3 to configure other office route selection codes (for example, 13).
Configuring Office Routes
In the current scenario, you need to configure the following office routes at node 1:
ϒ⁄Office route 12 to node 2, corresponding to office route selection code 12
ϒ⁄Office route 13 to node 3, corresponding to office route selection code 13
1.Choose Trunk > Office Route Configuration > Office Route.
2.Click Create.
3.Configure an office route (for example, 12) and click OK.
4.Repeat steps 2 and 3 to configure other office routes (for example, 13).
Configuring Prefixes
In the current scenario, you need to configure the following prefixes at node 1:
ϒ⁄Prefix 7 to node 2. The corresponding call attribute is local call and office route selection code is 12.
ϒ⁄Prefix 6 to node 3. The corresponding call attribute is local call and office route selection code is 13.
1.Choose Trunk > Called Prefix Configuration.
2.Click Create.
3.Configure a prefix (for example, 7) and click OK.
4.Repeat steps 2 and 3 to configure other prefixes (for example, 6).
Configuring SIP Trunks
In the current scenario, you need to configure the following SIP trunks at node 1:
ϒ⁄SIP trunk to node 2, corresponding to office route 12
ϒ⁄SIP trunk to node 3, corresponding to office route 13
1.Choose Trunk > Trunk Configuration > SIP.
2.Click Add A Peer Office.
The connection between the local office and the peer office is displayed.
3.Click the line between Local and point:0.
4.Configure a SIP trunk and click OK.
5.Repeat step 2 through step 4 to configure SIP trunks to other nodes.
6.Click Data Save in the upper right corner of the web management system portal.
Follow-up Procedure
Configure the interconnection data at the other nodes, for example, nodes 2 and 3 in this scenario.
Parent Topic: Multi-Node Network Scenario (Peer-to-Peer)